Ipv6 Is-Is Mtr Configuration Example - HP MSR2000 series Configuration Manual

Switch A)
Destination IP: FE80::20F:FF:FE00:1200 (link-local address of VLAN-interface 10 on
Switch B)
Session State: Up
# Display routes destined for 2001:4::0/64 on Switch A.
<SwitchA> display ipv6 routing-table 2001:4::0 64 verbose
Routing Table :
Summary Count : 1
Destination
NextHop
IpPrecedence :
RelayNextHop : ::
Neighbor
Interface
State
Tunnel ID
Age
The output shows that Switch A and Switch B communicate through VLAN-interface 10.
When the link over VLAN-interface 10 fails, BFD can quickly detect the failure.
# Display the BFD information on Switch A.
<SwitchA> display bfd session
Switch A has deleted the BFD session on VLAN-interface 10 to Switch B and displays no output.
# Display routes destined for 2001:4::0/64 on Switch A.
<SwitchA> display ipv6 routing-table 2001:4::0 64 verbose
Routing Table :
Summary Count : 1
Destination
NextHop
IpPrecedence :
RelayNextHop : ::
Neighbor
Interface
State
Tunnel ID
Age
The output shows that Switch A and Switch B communicate through VLAN-interface 11.

IPv6 IS-IS MTR configuration example

Network requirements
As shown in
in IPv4 and IPv6 topologies.
Source IP: FE80::20F:FF:FE00:1202 (link-local address of VLAN-interface 10 on
Hold Time: /
: 2001:4::0
: 2001::2
: ::
: Vlan-interface10
: Active Adv
: 0x0
: 4538sec
: 2001:4::0
: 2001:2::2
: ::
: Vlan-interface11
: Active Adv
: 0x0
: 4610sec
Figure 1 15, enable IPv6 IS-IS MTR to make the switches perform route calculation separately
Interface: Vlan10
320
PrefixLength : 64
Preference : 15
QosLcId :
Tag : 0H
ProcessID : 0
Protocol : ISISv6
Cost : 20
Label : NULL
PrefixLength : 64
Preference : 15
QosLcId :
Tag : 0H
ProcessID : 0
Protocol : ISISv6
Cost : 30
Label : NULL