Rip Configuration Examples; Configuring Rip Version - HP MSR2000 series Configuration Manual

Task
Display RIP current status and
configuration information.
Display all active routes in RIP
database.
Display RIP interface information.
Display routing information about
a specified RIP process.
Reset a RIP process.
Clear the statistics of a RIP process.

RIP configuration examples

Configuring RIP version

Network requirements
As shown in
Figure 10 Network diagram
Configuration procedure
Configure an IP address for each interface. (Details not shown.)
1.
Configure basic RIP functions:
2.
# Configure Switch A.
[SwitchA] rip
[SwitchA-rip-1] network 192.168.1.0
[SwitchA-rip-1] network 172.16.0.0
[SwitchA-rip-1] network 172.17.0.0
[SwitchA-rip-1] quit
# Configure Switch B.
[SwitchB] rip
Figure 10, enable RIPv2 on all interfaces on Switch A and Switch B.
Command
display rip [ process-id |
vpn-instance vpn-instance-name ]
[ | { begin | exclude | include }
regular-expression ]
display rip process-id database [ |
{ begin | exclude | include }
regular-expression ]
display rip process-id interface
[ interface-type interface-number ]
[ | { begin | exclude | include }
regular-expression ]
display rip process-id route
[ ip-address { mask | mask-length }
| peer ip-address | statistics ] [ |
{ begin | exclude | include }
regular-expression ]
reset rip process-id process
reset rip process-id statistics
37
Remarks
Available in any view
Available in any view
Available in any view
Available in any view
Available in user view
Available in user view