Configuring A Dr Priority For An Interface - HP MSR2000 series Configuration Manual

Step
2. Enter interface view.
3. Configure the hello interval.
4. Specify the poll interval.
5. Configure the dead interval.
6. Configure the LSA
retransmission interval.
7. Configure the LSA
transmission delay.
8. Return to system view.
9. Enter OSPFv3 view.
10. Configure the SPF timers.

Configuring a DR priority for an interface

Step
1. Enter system view.
2. Enter interface view.
Command
interface interface-type
interface-number
ospfv3 timer hello seconds
[ instance instance-id ]
ospfv3 timer poll seconds
[ instance instance-id ]
ospfv3 timer dead seconds
[ instance instance-id ]
ospfv3 timer retransmit interval
[ instance instance-id ]
ospfv3 trans-delay seconds
[ instance instance-id ]
quit
ospfv3 [ process-id ]
spf timers delay-interval
hold-interval
Command
system-view
interface interface-type
interface-number
285
Remarks
N/A
Optional.
By default, the hello interval on
P2P, broadcast interfaces is 10
seconds.
Optional.
By default, the poll interval is 120
seconds.
Optional.
By default, the dead interval on
P2P, broadcast interfaces is 40
seconds.
The dead interval set on
neighboring interfaces cannot be
too short. Otherwise, a neighbor is
easily considered down.
Optional.
By default, the LSA retransmission
interval is 5 seconds.
The LSA retransmission interval
cannot be too short; otherwise,
unnecessary retransmissions
occur.
Optional.
By default, the LSA transmission
delay is 1 second.
N/A
N/A
Optional.
By default, delay-interval is 5
seconds and hold-interval is 10
seconds.
Setting both the delay-interval and
hold-interval to 0 triggers an SPF
calculation at once, improving the
network convergence speed.
Remarks
N/A
N/A