Configuring Is-Is Route Redistribution - HP MSR2000 series Configuration Manual

System Id: 0000.0000.0002
Interface: Vlan-interface100
State: Up
[SwitchD] display isis interface
Interface: Vlan-interface100
Id
001

Configuring IS-IS route redistribution

Network requirements
As shown in
to interconnect. Switch A and Switch B are Level- 1 routers, Switch D is a Level-2 router, and Switch C is a
Level- 1 -2 router.
Redistribute RIP routes into IS-IS on Switch D.
Figure 65 Network diagram for IS-IS route redistribution
Configuration procedure
Configure IP addresses for interfaces. (Details not shown.)
1.
Configure IS-IS basic functions:
2.
# Configure Switch A.
<SwitchA> system-view
[SwitchA] isis 1
[SwitchA-isis-1] is-level level-1
[SwitchA-isis-1] network-entity 10.0000.0000.0001.00
[SwitchA-isis-1] quit
[SwitchA] interface vlan-interface 100
[SwitchA-Vlan-interface100] isis enable 1
[SwitchA-Vlan-interface100] quit
HoldTime: 28s
Interface information for ISIS(1)
---------------------------------
IPV4.State
Up
Figure 65, Switch A, Switch B, Switch C, and Switch D reside in the same AS. They use IS-IS
Circuit Id: 0000.0000.0001.01
Type: L2
IPV6.State MTU
Down 1497
169
PRI: 64
Type DIS
L1/L2 No/No