Editing A Method Table - ABB PGC2000 Operation And Service Manual

14. Enter "30" for Component #1's time and then cursor right to select "Component." Since this is the
first component entered into the table, "Undefined" will appear in the Value column.
15. Cursor right to the Value column. The Component Definition screen will appear (see Figure 4-
17), which will allow you to define this component. Cursor to each line in turn and enter the
appropriate data.
16. Review each line to ensure you have entered the correct data and then press the F1 (Continue)
soft key.
17. When the Method Table #01 screen appears, enter the data for the remaining items in the
Method Table. Remember to name Component Two "B" and Component Three "C."
18. When you have completed all lines in the Method Table, review the table to ensure all data are
correct and then press the F1 (Exit) soft key.
19. On the Method Table #01 screen, press the F2 (Exit and Update) soft key to save this Method
Table.

Editing a Method Table

The procedure for editing a method table is the same as that for preparing a new table. Follow the
applicable steps in "Preparing a Method Table" to access the particular screen to be changed and
then insert the new information in place of the information already existing.
If the data to be revised exists in the time-related portion of the method table, perform the following
steps to edit the table:
1. Access the method table as described in "Preparing a Method Table," steps 1 to 3.
2. In step 3 insert the desired method number and then proceed to step 4.
2000-OSM, F1
****** Component Definition
Name: [ ONE ]
Units: PPM %
Key Component:
Retention Time Dev:
Response Factor:
Calibration Concentration:
Benchmark Concentration:
High Concentration Alarm:
Low Concentration Alarm:
More Below
Continue
F1 F2
Figure 4-17. COMPONENT DEFINITION SCREEN
Calculated
No Yes
± 5.0000000 secs
1.0000000
100.00000
100.00000
100.00000
0.0000000
F3
******
F4
4-18