ORDERING INFORMATION
Since the component parts specific to any given system are defined by the
particular application, you should refer to the "Recommended Spare Parts Lists" in
the Data Package supplied with the analyzer, to obtain the full and correct part
number for the desired part or assembly.
Equipment Identification
The following information, found in the Data Package and on the analyzer nameplate, should be
included in any communication concerning replacement parts or components:
•
ABB Sales Order Number.
•
Analyzer Model Number.
•
Analyzer Part Number (P/N) and serial number.
•
For serial numbered subassemblies such as PC boards, include the serial number and the part
number (including dash number and revision letter) for the subassembly in the request. If a PC
board requires conformal coating, prefix the PCB part number with the letters "CC."
•
Applicable references from the "Recommended Spare Parts List" of the Data Package, included
with each analyzer.
•
Description of part.
Hardware Configuration Identification
The nameplate (see Figure 9-1), which is located on the right side of the Oven Compartment, lists the
hardware configuration information.
The hardware configuration consists of the model number, sales order number, and T-Rating.
9-1
SECTION 9. REPLACEMENT PARTS
Sales
ATEX
Order No.
S.O. NO.:
YEAR OF MANUFACTURE:
II 2G EEx pde [ib] ib [ia] IIB+H2 T
ATEX 6025X
Figure 9-1. TYPICAL NAMEPLATE
NOTE
ABB INC.
LEWISBURG, WV 24901
MADE IN U.S.A
0344
MODEL:
T-Rating
Model No.
2000-OSM, F1