Typical Show Registers Screen - ABB PGC2000 Operation And Service Manual

Show Registers: Entered as SR (see Figure 8-45). The internal register contents of the 80C152
microcontroller are shown. Refer to the manufacturer's data sheet for an explanation of the contents.
Type MM to return to the Main Menu.
Ignore Token: Entered as IT, used for software loading tests. In this mode, the communications
board remains part of the token bus, however tokens are merely passed, and no UDP packets are
transmitted or received at this node. THIS COMMAND IS NOT TO BE USED IN THE FIELD.
Main Menu: From the SFR display, this command returns to the main menu.
Vistanet Debugger - HyperTerminal
File Edit
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
GSC
ADR0:8E
BKOFF:09
MYSLOT:3F
DMA
BCRM0:02
BCRH1:00
INTERRUPT
IE:F3
POWER CONTROL
PCON:C0
LSC
SCON:54
TIMER
TCON:D0
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
Connected 0:00:27
The Promiscuous Mode command is used only in the factory.
Promiscuous Mode: Entered as PM, this command is used in software
mode, this node receives all UDP packets, whether destined for this station or not.
Reset Statistics: Entered as RS, this command resets the cumulative statistics collected at this
node.
Reset stats Globally: Entered as RG, this command resets all cumulative statistics collected at all
nodes by sending a reset statistics command to all nodes by transmitting a special token.
8-68
View Cell Transfer Help
ADR1:01 ADR2:8E
AMSK0:00 AMSK1:00
SLOTTM:01 TCDCNT:00 TSTAT:87
BCRL0:0D DARH0:77 DARL0:C4
BCRL1:00 DARH1:00 DARL1:85
IEN1:C7 IF:E0
TH0:D1 TL0:D8
9600 8-N-1
VT100
Figure 8-45. TYPICAL SHOW REGISTERS SCREEN
VistaNet Monitor
SFR Display
ADR3:01 BAUD:00
GMOD:1C IFS:65
RSTAT:03
SARH0:00 SARL0:F4
SARH1:03 SARL1:8B
IPN1:C3
TH1:FA TL1:FF TMOD:21
WARNING
DCON0:69
DCON1:00
troubleshooting. In this
2000-OSM, F1