Manual Control Mode Screen - ABB PGC2000 Operation And Service Manual

2. On the Manual Control Mode screen (see Figure 2-16), cursor down to CHROMA, then left to
OFF.
3. Press the ENTER key. The recorder turns off.
4. Cursor to CHROMA and then press the ENTER key. The recorder turns on and will record the
chromatogram.
5. When the chromatogram is complete, press the F1 soft key as necessary to return to the
Background screen.
Displaying a Chromatogram
1. On the Background screen press the F2 (Manual Control) soft key.
2. On the Manual Control Mode screen press the F2 (Detector and Graphics) soft key.
3. On the Chroma Board screen press the F2 (Graphics) soft key.
4. On the Graphics Mode screen press the F2 (Display the Graphics) soft key. A chromatogram will
scroll up the screen as it happens. A baseline at mid-screen is good.
5. When you have completed the chromatogram display, press the F1 soft key as necessary to
return to the Background screen.
Displaying the Percent Offset
1. On the Background screen press the F2 (Manual Control) soft key.
2. On the Manual Control Mode screen press the F3 (Manually Zero Baseline) soft key.
2000-OSM, F1
****** Manual Control Mode
Valves:- - - - - - - -
Enter Valve: [0]
RECORDER:
Offset :
Attn :
Off Chroma Bar Trend
PURGE SELECT: :0
Start Crest
Time Time
Last: 52 55
38 43
Exit Detector
To and
Background Graphics
F1 F2
Figure 2-16. MANUAL CONTROL MODE SCREEN
Time:00000
Cycle Time:00000
Method Tbl:
0 % Stream:
5 Purging:
Peaks:
State: Idle
End Peak
Time Area
73 18032
51 15322
Manually
Zero
Baseline
F3
******
000
01
01
00
Type
Val-Bas
Bas-Val
Press. &
Temp.
Control
F4
2-27