Control Parameters Screen - ABB PGC2000 Operation And Service Manual

Parameters) soft key. On the Control Parameters screen (see Figure 4-9), cursor down the
selections until "Detector 1 Mode" and "Detector 2 Mode" appear. Select the desired mode for
Detector 2 and then press the F2 (Exit and Update) soft key to save this setting.
The Stream Assignment screen adds two columns to its standard screen (see Figure 4-10), one to
identify the detector used for each stream and method (Det), the other to identify the link between
master and slave (Link).
Stream
4-9
********** Control Parameters
Update Trends on Alarm:
Auto Update of RF:
Max RF Variation:
Unknown Peak RF:
Unknown Peak Units:
Slope Detect Tics: Never
Detector 1 Mode: Master
Detector 2 Mode: Master Slave
Analyzer Name:
Exit
Escape and
Update
F1 F2
Figure 4-9. CONTROL PARAMETERS SCREEN
****** Stream Assignment
Status Method Basic Det Link
01 Active 01
02 Active 02
03 Active 01
04 Active 02
05 Inactive 01
06 Inactive 01
07 Inactive 01
08 Inactive 01
Exit
F1 F2
Figure 4-10. STREAM ASSIGNMENT SCREEN
No Yes
No
0.000000
0.000000
% ppm
Last First
More Below
Alarm Common
Mask Digital
Out. Mask
F3
00 01 02
00 02 00
00 01 04
00 02 00
00 01 00
00 01 00
00 01 00
00 01 00
F3
**********
Yes
F4
******
F4
2000-OSM, F1