Calibration Run - ABB PGC2000 Operation And Service Manual

4. Press the F2 (Test Printer) soft key. A string of characters should print. If characters print go to
step 5. If a string of characters does not print go to step 9.
5. Verify that the cursor is on PRINTER.
6. Press the F3 (Print Tables) soft key.
7. Select a table to print. Repeat until you have printed all tables.
8. Verify that the printed tables are the same as those in the Data Package. If so, go to "Calibration
Run."
9. If a string of characters did not print when you selected Test Printer, cursor to TESTING/SET UP.
10. Press the F3 (Hardware Set Up) soft key.
11. On the Hardware Set Up screen, verify that the baud rate, parity, data bits, and stop bits values
match those set at the printer. Refer to the printer manual if necessary.
12. Press the F2 (Exit & Update) soft key and return to the Commands screen.
13. Perform steps 3 through 8.

Calibration Run

If you have a calibration run specified for your analyzer, request a calibration and compare the results
with those in the Data Package. To do this perform the following steps (which will enable you to
perform a single calibration run):
1. On the Background screen press the F1 (Exit to Commands) soft key.
2. On Commands screen cursor to TABLE EDIT and press the F2 (Methods) soft key.
3. The Method Table #?? screen will appear. Use the number keys on the GCC front panel to enter
the number of the method to be calibrated. When the desired number appears on the screen,
press the F2 (Edit The Table) soft key.
4. The Cal Define & Cycle Time screen will appear. Note the calibration stream number that
appears on the Primary Cal Stream line.
5. Press the F1 (Continue) soft key.
6. When the next Method Table screen appears, press the F1 (Exit) soft key, then press the F1
(Escape) soft key.
7. When the Commands screen appears, cursor to ANALYSIS CONTROL and then press the F2
(Request Analysis) soft key.
2000-OSM, F1 2-21