Saving Settings On A Pc - Siemens SINAMICS G120 Operating Instructions Manual

7.2

Saving settings on a PC

You can transfer the inverter settings to a PG/PC, or vice versa, the data from a PG/PC to
the inverter.
Requirements
• The inverter power supply has been
switched on.
• You have installed one of the
commissioning tools STARTER or
Startdriveto your PG/PC.
inverter (Page 51)
Inverter → PC/PG
Procedure with STARTER
To back up the settings with STARTER, proceed as follows:
1. Go online:
2. Click the "Download project to PG" button:
3. Save the project:
4. Wait until STARTER reports that data backup has been completed.
5. Go offline:
You have backed up the settings with STARTER.
Procedure with Startdrive
To back up the settings with Startdrive, proceed as follows:
1. Go online.
2. Select "Online" > "Upload device to PG/PC."
3. Back up the project with "Project" > "Save."
4. Wait until Startdrive reports that data backup has been completed.
5. Go offline.
You have backed up the settings with Startdrive.
Converter with the CU240B-2 and CU240E-2 Control Units
Operating Instructions, 01/2016, FW V4.7 SP6, A5E34259001B AC
Tools to commission the
.
.
.
Backing up data and series commissioning
7.2 Saving settings on a PC
.
363