Configuring The Ip Interface - Siemens SINAMICS G120 Operating Instructions Manual

Advanced commissioning
6.2 Inverter control
6.2.10.7

Configuring the IP interface

Configure communication with STARTER
STARTER provides a screen form to set the communication with the control system.
Open the dialog screen form "Control_Unit/Communication/Commissioning interface" and
activate the "Configure IP interfaces" tab
● Set the DHCP mode to 0 (factory setting).
● Enter the device name, address, gateway and the address for the subnet mask.
● In the Activation field select "[2] Save and activate configuration".
● To activate the settings, you must switch off the inverter power supply and then switch on
again.
You can also enter or read out data using the expert list. You can find the corresponding
parameters in the number range r8909 ... p8925
208
Converter with the CU240B-2 and CU240E-2 Control Units
Operating Instructions, 01/2016, FW V4.7 SP6, A5E34259001B AC