Table of Contents
Advertisement
Waukesha Cherry-Burrell Brand Universal TS Series
Replacement Labels
WARNING
The following labels are installed on your equipment. If these labels are removed or become unreadable,
contact SPX FLOW customer service at 800-252-5200 or 262-728-1900, and refer to the part numbers below.
Application Instructions
Apply to a clean, dry surface. Remove the backing from the label, place it in proper position, protect it with a
cover sheet and burnish it. (A soft rubber roller also may be used to press the label into place.) Apply all labels
to be readable from the front of the pump.
Part no: 33-63
The labels above are affixed to the pumps as shown. (130-UTS pump is shown. Label placement is similar
on other sizes.) If the pump is mounted on a bracket, the "Read and understand operation manual" label is
placed on the arm of the bracket.
Part no: 33-95
This label is supplied on
base packages, on the side
of the gear case.
06/2017
WARNING
KEEP FINGERS
OUT OF PORTS
This label is supplied with pumps with double
mechanical seals. It is attached to the eye bolt.
95-03141
Replacement Labels
Part no: 121694+
Label locations-UTS
Part no: 112446+
Page 9
Advertisement
Table of Contents
Need help?
Do you have a question about the Universal TS Series and is the answer not in the manual?