Install Body - SPX FLOW Universal TS Series Instruction Manual

Waukesha Cherry-Burrell Brand Universal TS Series
Figure 76 - Install seal
Figure 77 - Lubricate O-rings
Figure 78 - Install shaft O-rings
06/2017
18. (Double seal only) Align the drive slots in the seal with the
pins on the seal carrier, then press the seal into the carrier.
NOTE: This may require a hard push, but use caution not to
break the seal.
19. (Double seal only) Repeat steps 17 and 18 to install the seal
in the second seal carrier.

Install body

For a single seal, skip to step 5 on page 44.
For a double seal, continue.
1. (Double seal only) Lubricate two shaft O-rings.
2. (Double seal only) Install one O-ring on each shaft in the O-
ring groove closest to the gear case, as shown in Figure 78.
95-03141
Maintenance
Page 43