SPX FLOW Universal TS Series Instruction Manual page 47

Waukesha Cherry-Burrell Brand Universal TS Series
Figure 82 - Pump body installed
Figure 83 - Apply anti-seize to threads
Figure 84 - Install body retaining screws
Figure 85 - Install shaft O-ring
06/2017
6. Pump body installed, shown in Figure 82.
7. Apply anti-seize to the threads of the body retaining screws.
8. Using an Allen wrench, install the two body retaining screws
in the holes next to the dowel pins, and hand-tighten. (220-
UTS shown.)
9. If the seal has already been installed, lubricate the shaft O-
ring, then slide the shaft O-ring over the shoulder in the shaft,
and install it into the O-ring groove. See Figure 85.
Repeat for the second shaft, then skip to "Seal cap assembly"
on page 47.
95-03141
Maintenance
Page 45