Remove Pump Body - SPX FLOW Universal TS Series Instruction Manual

Maintenance
Figure 44 - Remove seal wave spring
Figure 45 - Remove body retaining screws
Figure 46 - Remove pump body
Page 34
Waukesha Cherry-Burrell Brand Universal TS Series
4. Remove and inspect the seal wave spring on each shaft.

Remove pump body

1. Using an Allen wrench, remove the two body retaining
screws. (The body retaining screws are located next to the
small dowel pins on the body. See the diagram on page 96.
The body retaining screws are item 11.)
2. Remove the pump body and place it on a protected surface.
When removing the pump body, be careful not to damage the
seals with the shafts.
For a double seal, continue.
For a single seal, skip to step 1 on page 36.
95-03141 06/2017