Chapter 5 Connecting The Management Interfaces And Performing Initial System Configuration; Introduction; How To Set Up The Local Console - Cisco SCE 2000 Installation And Configuration Manual

Connecting the Management Interfaces and
Performing Initial System Configuration
Revised: July 27, 2009, OL-7824-07

Introduction

This chapter explains how to connect the SCE 2000 platform to a local console and perform the initial
system configuration via the setup wizard that runs automatically.
Additionally, this chapter contains instructions for cabling the Fast Ethernet Management interfaces.
When installing a cascaded system, it is extremely important to follow the sequence of procedures
Note
outlined.
•
•
•

How to Set Up the Local Console

Even if you will be managing the SCE 2000 from a remote location, you must first connect the unit to a
local console and configure the initial settings for the SCE 2000 to support remote management
(Figure
prompting you to perform the initial system configuration.
This section provides instructions for setting up your local terminal at your workstation, to enable you
to perform the initial system configuration of the SCE 2000 system using the setup utility.
OL-7824-07
How to Set Up the Local Console, page 5-1
Initial System Configuration, page 5-3
Connecting the Management Interface, page 5-25
5-1). When the initial connection is established, the setup utility will run automatically,
C H A P T E R
Cisco SCE 2000 4xGBE Installation and Configuration Guide
5
5-1