Dell S6100 Configuration Manual page 1045

Hide thumbs Also See for S6100:

Table of Contents

Figure 160. VRRP for IPv6 Topology

This example does not contain comprehensive directions and is intended to provide guidance for only a typical VRRP

configuration. You can copy and paste from the example to your CLI. Be sure you make the necessary changes to support your

own IP addresses, interfaces, names, and so on.

In a VRRP or VRRPv3 group, if two routers come up with the same priority and another router already has MASTER

status, the router with master status continues to be master even if one of two routers has a higher IP or IPv6 address.

R2(conf)#interface tengigabitethernet 1/1/1/1

R2(conf-if-te-1/1/1/1)#no ip address

R2(conf-if-te-1/1/1/1)#ipv6 address 1::1/64

R2(conf-if-te-1/1/1/1)#vrrp-group 10

You must configure a virtual link local (fe80) address for each VRRPv3 group created for an interface. The VRRPv3 group

becomes active as soon as you configure the link local address. Afterwards, you can configure the group's virtual IPv6 address.

R2(conf-if-te-1/1/1/1-vrid-10)#virtual-address fe80::10

Virtual Router Redundancy Protocol (VRRP)

Troubleshooting