Table of Contents
Advertisement
Configuring Ethernet Settings
1
Press
(
2
Use
/
to select <Network>, and press
●
When a message appears, press
3
Select <Ethernet Driver>
4
Select whether to configure Ethernet settings automatically or manually.
Configuring Ethernet settings automatically
Select <On> and press
Ethernet type that can be used.
Configuring Ethernet settings manually
1
Select <Off>, and press
2
Select the communication mode.
●
Select <Communication Mode>
<Half Duplex>
Alternately sends and receives communication data. Select when the machine is connected to a
networking device using half duplex.
<Full Duplex>
Simultaneously sends and receives communication data. Use this setting for most environments.
Ethernet is a standard for communicating data in a local area network (LAN). You can set
the communication mode (half-duplex/full-duplex) and the Ethernet type (10BASE-T/
100BASE-TX/1000BASE-T). In general, the machine can be used without changing the
defaults (
Ethernet Driver(P. 385) ), but you can change these settings to suit your
network environment.
).
.
<Auto Detect>.
. The machine detects and automatically sets the communication mode and the
.
Network
.
Select <Half Duplex> or <Full Duplex>
210
167A-03E
Advertisement
Table of Contents
