Table of Contents
Advertisement
Installing the ROM
This section describes how to install the Barcode Printing Kit-F1 or PCL
International Font Set-C1 in the machine. The ROM is used connected to
the ROM connectors inside the right cover of the machine. Read the
precautions in
Installation(P. 3) before installing the ROM.
Precautions when installing the ROM
●
Do not cause any metal such as screws to come into contact with the circuit boards in the machine. Doing so
may result in damage to the machine.
●
Do not touch the internal parts, printed wiring, connectors, or switches. Doing so may result in damage to
the machine.
●
Do not turn ON the power when the ROM cover is open. Doing so may result in damage to the machine.
Precautions for avoiding static electricity
The ROM contains parts that are sensitive to static electricity. Observe the following precautions for preventing
the ROM from being damaged by static electricity.
●
Touch a metal portion in the room to discharge static electricity from your body before handling the ROM.
●
Do not touch any item that is likely to generate static electricity, such as a display, during work.
●
To avoid the influence of static electricity, do not remove the ROM from the protective bag until just before
connecting it to the ROM connectors.
1
Turn OFF the machine, and unplug the power plug from the AC power outlet.
●
When you turn OFF the power, shut down the machine from the operation panel without using the power
switch.
Turning OFF the Power (Performing a Shutdown)(P. 34)
2
Remove the right cover.
1
While pushing the catch, slightly open the cover toward you.
Appendix
565
167A-080
Advertisement
Table of Contents
