Table of Contents
Advertisement
●
Specify the correct range of print pages, and print the file again.
Printing from USB Memory (USB Direct Print)(P. 116)
Print Settings for Direct Print(P. 146)
Print data version error.
Printing has been tried from the printer driver that is not available for the machine.
●
Print again by using the printer driver available for this machine.
Set below paper.
Paper of the size specified to print is not loaded or the selected paper source does not match the paper
size.
●
Load the paper of the size specified to print in the selected paper source.
Loading Paper(P. 38)
●
Select the paper source loaded with the paper of the size specified to print.
Paper Source(P. 450)
●
To forcibly print on the loaded paper, press
specified for <MP Tray Paper Size> is automatically changed to the paper size of the print data.
Starting up... 80 Initializing MEAP. Do not turn power OFF.
You have tried to shut down the machine while MEAP was being initialized.
●
When the MEAP initialization is complete, this message is automatically removed. Wait until the message
is removed.
Starting up... 80 Preparing MEAP... Do not turn power OFF.
You have tried to shut down the machine while MEAP was preparing for operation.
●
When MEAP is ready for operation, this message is automatically removed. Wait until the message is
removed.
Syntax error.
Invalid data has been sent during printing with the UFR II printer driver.
●
Change the printer driver settings or the format of print data, and print the file again.
●
When you press
Toner cartridge will soon reach end of lifetime.
The replacement time for the toner cartridge is near.
●
Make sure that you have a replacement toner cartridge ready.
●
Replace the toner cartridge if you see this message before you start to print a large job.
Replacing Toner Cartridges(P. 510)
●
You can press
Troubleshooting
(
), the print job is canceled.
(
) to continue printing.
482
(
). For the multi-purpose tray, the setting
Advertisement
Table of Contents
