Table of Contents
Advertisement
2
SYSTEM CONFIGURATION
2.2.2
Setting items
In a single network system, the following items are to be set when the CC-Link IE
Controller Network board is used as a control station or a normal station.
CC-Link IE Controller Network board settings are configured in the CC IE Control utility.
Target board specification
Board
Channel No.
Operational
setting
Network
range
assignment
Driver setting
Event setting
Target setting
Refresh parameter setting
Routing parameter
2.2.3
Available device ranges
The following device ranges can be used on the CC-Link IE Controller Network board.
Device
LB
LW
LX
LY
2
- 3
2.2 Single Network System
2.2.2 Setting items
Setting item
Network type
Mode
Network No.
Group No.
Station No.
LB/LW settings
LX/LY settings
Specify reserved
station
Supplementary
setting
: Setting required : Set as necessary : Setting not required
Available range
0
to 7FFF
(32768 points)
H
H
0
to 1FFFF
(131072 points)
H
H
0
to 1FFF
(8192 points)
H
H
0
to 1FFF
(8192 points)
H
H
Control station
Normal station
The ranges for each CC-Link IE Controller Network
board and network module need to be assigned in the
parameter setting for the control station.
The ranges for each CC-Link IE Controller Network
board and network module need to be assigned in the
parameter setting for the control station.
Reference
Section 8.4.1
Section 8.4.2
Section 8.4.5
Section 8.4.6
Section 8.4.7
Section 8.4.8
Section 8.4.9
Section 8.4.4
Remarks
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
