5
PROCEDURES AND SETTINGS BEFORE OPERATION
5.4.2
Wiring external power supply cable
This section explains the method for connecting external power supply cable to the CC-
Link IE Controller Network board with external power supply function.
(1) Connection procedure
Wire external power supply cable.
Connect the external power supply cable.
(2) Parts and tools required for external power supply cable
5
- 15
5.4 Wiring
5.4.2 Wiring external power supply cable
The following flowchart shows a procedure for connecting external power supply
cable.
Start
Check the required parts.
End
The following parts and tools are required for making external power supply cable.
(a) Connector set (accessories)
Check that the following parts are included with the attached connector set.
Type
Connector
Contact
(b) Cable
Use an external power supply cable with heat-resistant vinyl sheath of 0.5 to 1.25
2
mm
[AWG#20-16].
(c) Tool
Use the following specified crimp tools.
Model
91558-1
1762956-1
(2) Parts and tools required for external
power supply cable in this section
(3) Making external power supply cable
in this section
(4) Connecting external power supply
cable to the board in this section
Model name
Applicable wire size
1-178288-3
—
175218-2
AWG#20-16
Applicable wire size
AWG#20-16
Quantity
1
3 (Spare 1)
Inquiry
Tyco Electronics