Appendix 3.1 Parameter File; File Output - Mitsubishi Electric Q80BD-J71GP21-SX User Manual

APPENDICES
Appendix 3 File Output
This section explains files to be saved in the CC IE Control utility.

Appendix 3.1 Parameter file

The default directory for the storage location (load source) of files to be used in the CC IE
Control utility is "(install directory) \MNETG\PARAM". The default for the file name of
dialog box displayed during saving is blank.
Parameters set by the current CC IE Control utility are saved in the file of the development
environment (personal computer) when the
setting" screen.
When the
CC IE Control utility.
When the attempt to end the CC IE Control utility is made without saving a file after
changing the parameter setting, a confirmation message is displayed.
POINT
button is clicked, parameters saved in the file can be loaded to the
Load file
• The data to be saved in the file are the parameters of the boards checked
under "Target board specification" on the "Parameter setting" screen.
• When reading data from the file, if parameters different from the checked
status of Board 1 to 4 under "Target board specification" on the
"Parameter setting" screen are read, the
Change the parameters to match with the checked status of Board 1 to 4.
For changing the board number, restart the personal computer after
changing the channel number in "Channel No." on the "Parameter
setting" screen. For assigning the board numbers and channel numbers,
refer to the following section.
Section 6.1 Parameter Settings (Board Information
Settings)(<Assigning channel numbers to the CC-Link IE Controller
Network boards>, <Assigning board numbers in the CC IE Control
utility>)
button is clicked on the "Parameter
Save file
button cannot be clicked.
END
Appendix 3 File Output
Appendix 3.1 Parameter file
9
10
11
12
13
14
A
I
App
- 16