Mitsubishi Electric Q80BD-J71GP21-SX User Manual page 183

13
ERROR CODES
(7) Event setting screen
Error message
The event No. is outside the range.
Please input a value within the range 0-63.
The device No. is outside the range.
Please input each device within the following ranges.
LB:0000-7FFF
LW:0000-1FFFF
LX:0000-1FFF
SB:0000-01FF
SW:0000-01FF
The device size is outside the range.
Please input it on the following conditions.
Input within the range of 1-64. (device No. + device size - 1)
must not exceed the upper bound of device No.
The word device is outside the range.
Please input a value within the range 1-65535.
The event No. XX is overlapping. Please correct the
settings.
(8) Target setting screen
Error message
The logical station number setting value is outside the
range.
Please input a value within the range 0-239.
The network No. setting value is outside the range.
Please input the value within the range 1-239.
The station number setting value is outside the range.
Please input a value within the range 0-120.
The logical station number XX is overlapping.
Please correct the settings.
Specification of PLC is unsuitable. Please specify PLC.
(9) Refresh parameter setting screen
Error message
Link side number of points is out of range.
Set it within the range of XX to YY.
Link side start device No. is out of range.
Set it within the range of XX to YY.
Link side end device No. is out of range.
Set it within the range of XX to YY.
Device setting is overlapping.
Correct these settings.
Set the value for the event number within the range of 0 to 63.
Set the values for the device number within the following
ranges to each device specified by device codes.
LB:0000-7FFF
LW:0000-1FFFF
LX:0000-1FFF
SB:0000-01FF
SW:0000-01FF
Set the value for the device size within the range of 1 to 64,
and (device No. + device size - 1) should not exceed the
maximum value of the device number.
Set the value for the word device within the range of 1 to
65535.
Set the event numbers not to overlap.
Set the value for the logical station within the range of 0 to 239.
Set the value for the network number within the range of 1 to
239.
Set the value for the station number within the range of 0 to
120.
Set the logical station numbers not to overlap.
Specify the programmable controller CPU.
Set the value for link side number of points within the range of
XX to YY.
Set the value for link side start device number within the range
of XX to YY.
Set the value for link side end device number within the range
of XX to YY.
Set the device ranges not to overlap.
13.1 List of Error Messages in CC IE Control Utility
13.1.2 Error messages displayed on the setting screen
Corrective action
Corrective action
Corrective action
9
10
11
12
13
14
A
I
13
- 6