List Of Error Messages In Device Monitor Utility - Mitsubishi Electric Q80BD-J71GP21-SX User Manual

13
ERROR CODES

13.2 List of Error Messages in Device Monitor Utility

The following explains the corrective actions to error messages in the Device monitor
utility.
Error message
DEC input range error.
Input 0-9.
HEX input range error.
Input 0-9, A-F.
Input Error.
Input 0-7
Station No. is not input.
Station No. is out of the range.
The device that can use in this function dose not exist.
Setting points are out of the range.
Setting data are not input.
It cannot communicate XX : YY
Error code : ZZ (signed decimal)
Channel information is not register.
It is fail to get the channel information.
Device data are out of the range.
Device No. is not input.
Device No. is out of the range.
Points are not input.
Network No. is not input.
Network No. is out of the range.
Block No. / Network No. is not input.
Block No. / Network No. is out of the range.
The necessary information is not found at the time of starting
up.
Install again.
13
- 11 13.2 List of Error Messages in Device Monitor Utility
Corrective action
Input a decimal number in the range of 0 to 9.
Input a hexadecimal number in the range of 0 to 9, A to F.
Input a octal number in the range of 0 to 7.
Input a station number.
Check the range of the station number, and Input.
Select a device that can be used for the function.
Check the range of the setting point, and Input.
Input a setting data.
Refer to the error list of MELSEC Data Link Library
Reference Manual.
• Update the parameter again.
• Restart the developing environment (personal computer).
• Reinstall SW1DNC-MNETG-B.
• Update the parameter again.
• Restart the developing environment (personal computer).
• Reinstall SW1DNC-MNETG-B.
Check the setting of the device data.
Input a device number.
• Check the device number and set.
• Check the block number of the specified device (device
type).
• Check if the specified device and block number are valid
for the specified target.
Input a point.
Input a network number.
Check the range of the network number, and input.
Input a block number.
Check the range of the block number, and input.
The installation of SW1DNC-MNETG-B may be failed.
Reinstall SW1DNC-MNETG-B.