Mitsubishi Electric Q80BD-J71GP21-SX User Manual page 65

5
PROCEDURES AND SETTINGS BEFORE OPERATION
(3) Making external power supply cable
The following explains the method for making external power supply cable.
(a) Crimping a contacting pin
(b) Check for a crimp
(c) Connecting to the connector
(4) Connecting external power supply cable to the board
Properly insert the wired external power supply cable to the external power supply
cable connector of the CC-Link IE Controller Network board until a click is heard.
Keep the cable away from the main circuit cable, power cables and/or the load cables
for any other than programmable controllers. Ensure a distance of 100 mm (3.94 in.)
between them.
POINT
Using a crimp tool, crimp the cable and contacting pin.
Set the contacting pin and cable in the grooves of the crimp tool, squeeze the
handle, and make them stick together tightly.
For details of the crimp, refer to the instruction of the tool.
A strip length of the cable should be 5 to 7 mm (1/5 to 2/7 in.)
Check if the cable (including a part of the sheath)
is evenly crimped to the contacting pin.
If the cable part is crimped but not the sheath part
or the cable is stuck out, the cable cut or a
malfunction may result.
According to the following pin-out, fully
insert the crimped cable to the connector
until a click is heard.
Pin No.
1
2
3
Be sure to twist the external power supply cable.
Connector
Contacting pin
Description
24V
24G
Open
5.4.2 Wiring external power supply cable
Contacting pin
Cable
24V
24G
5
5.4 Wiring
- 16
1
2
3
4
5
6
7
8