Operating Procedure - Mitsubishi Electric Q80BD-J71GP21-SX User Manual

8
CC IE Control UTILITY
8.2

Operating Procedure

This section explains the operating procedure of the CC IE Control utility.
Connect the personal computer to the CC-Link IE Controller Network.
Set the channel number and operation settings (network type, mode,
network number, group number, and station number) of the target
board on the "Parameter setting" screen.
When the station is used as a control station, set the parameters on
the "Network range assignment" screen.
Set the parameters on the "Routing parameter setting" screen for
accessing the other network.
Set the parameters on the "Driver setting" screen for setting
Driver WDT monitoring time and Transient timeout monitoring time.
Set the parameters on the "Event setting" screen for using the
event function.
Set the parameters on the "Target setting" screen for using logical
station numbers.
Set the parameters on the "Refresh parameter setting" screen for
setting refresh ranges.
Check the status of the network link and stations on the
"CC-Link IE Controller Network diagnostics result" screen.
Check the path for communicating with the specified station on the
"Communication test" screen.
Execute the data link start/stop for each station on the "Link start/stop"
screen.
Check the transmission path switch information and transient
transmission errors on the "Logging" screen.
Check the channel numbers on the "Channel No. confirm" screen.
Check the information on the CC-Link IE Controller Network board on
the "Board detail information" screen.
Start
Start the CC IE Control utility.
End the CC IE Control utility.
End
Section 5.1 Procedure before
Operation
Section 8.2.1 Starting the utility
Section 8.4.1 Parameter setting
screen
Section 8.4.2 Network range
assignment screen
Section 8.4.4 Routing parameter
setting screen
Section 8.4.6 Driver setting screen
Section 8.4.7 Event setting screen
Section 8.4.8 Target setting screen
Section 8.4.9 Refresh parameter
setting screen
Section 8.5.1 CC-Link IE
Controller Network diagnostics
result screen
Section 8.5.2 Communication
test screen
Section 8.5.3 Link start/stop screen
Section 8.5.4 Logging screen
Section 8.3.2 Channel number
confirmation screen
Section 8.3.3 Board detail
information screen
Section 8.2.2 Ending the utility
8.2 Operating Procedure
1
2
3
4
5
6
7
8
8
- 3