Setting Items; Usable Device Ranges - Mitsubishi Electric SW0DNC-MNETH-B User Manual

2 SYSTEM CONFIGURATION

2.2.3 Setting items

2.2.4 Usable device ranges

2 - 4
In a single network system, the items which need to be set in the case that the
MELSECNET/H board is used as the control station or normal station are as follows.
MELSECNET/H board settings are set by the MNETH Utility.
Setting item
Channel setting
Network No.
Group No.
Station No.
Control station/ Normal station
Mode Setting
Routing parameter setting
B, W setting
Common
X, Y setting
parameter
Reserved station setting
setting
Supplementary setting
Opposite party setting
(Logical station No.)
Driver setting
: Setting necessary
The MELSECNET/H board can be used within the following device ranges for the
following devices on the MELSECNET/H board.
Device Usable range
0 to 3FFF
H
LB
(16384 points)
0 to 3FFF
H
LW
(16384 points)
0 to 1FFF
H
LX
(8192 points)
0 to 1FFF
H
LY
(8192 points)
If the MELSECNET/H board is used in the MELSECNET/10 mode, the device range
for LB/LW becomes 0
H
Control station
: Set as necessary
The function expansion areas of 2000
H
the low-speed cyclic transmission. All areas can be used for the
normal cyclic transmission.
The use ranges for each MELSECNET/H board and network
H module need to be assigned in the parameter settings for the
control station.
H
The use ranges for each MELSECNET/H board and network
module need to be assigned in the parameter settings for the
control station.
H
to 1FFF (8192 points).
H
MELSEC
Normal station Reference section
Section 9.2.2
Section 9.2.3
Section 9.2.4
Section 9.2.5
Section 9.2.10
Section 9.2.11
: Setting unnecessary
to 3FFF are used for
H H
2 - 4