Target Setting Screen - Mitsubishi Electric Q80BD-J71GP21-SX User Manual

8
CC IE Control UTILITY
8.4.8

Target setting screen

This screen is displayed by clicking the
screen.
Section 8.4.1 Parameter setting screen
It is used to set logical station numbers for accessing the multiple CPU system or
redundant CPU system.
Item
Enter a logical station number to be set or
*1
Logical station No.
changed.
Network No. Set a network number of the access target.
Set a station number of the network module
Station No. that is controlled by the multiple CPU system
or redundant CPU system.
Specify the CPU number in the multiple CPU
Multiple PLC
system of the access target CPU.
Specify the system specification for the
Redundant PLC
redundant system of the access target CPU.
Batch-deletes the target settings.
Clear
Checks the target settings.
Check
Reflects the settings, and closes the "Target
End
setting" screen.
Without reflecting the settings, closes the
Cancel
"Target setting" screen.
Description
*1: Logical station numbers are logical numbers that are set to station numbers in the Device monitor
utility and user program (MELSEC data link function library). Logical station numbers are used
when accessing from the target board (channel number) to the other station CPU (other CPU
modules of multiple CPU system or system specified CPU module of redundant CPU system).
When directly accessing the CPU module that controls other stations (station number 1 to 120)
and their CC-Link IE Controller Network module, use not logical numbers but station numbers
used for CC-Link IE Controller Network.
button on the "Parameter setting"
Target setting
Default
—
—
—
—
CPU NO. 1 to CPU NO. 4
—
—
—
—
—
8.4 Setting Screen
8.4.8 Target setting screen
Setting range
0 to 239
1 to 239
1 to 120
No specification
No specification
Control system
Standby system
System A
System B
—
—
—
—
8
- 25
1
2
3
4
5
6
7
8