Error Messages Displayed On The Board Information Screen - Mitsubishi Electric Q80BD-J71GP21-SX User Manual

13
ERROR CODES

13.1.1 Error messages displayed on the board information screen

(1) Board list screen (start screen)
Error message
Only one CC IE Control utility can be started.
CC IE Control utility has already been started.
Failed to open the Help file.
Failed to start up the Device monitor utility.
Driver is not started.
A CC-Link IE Controller Network board is not mounted.
Mount a board then start utility.
Failed to read the version information.
(2) Channel number confirmation screen
Error message
LED cannot be displayed because of boardXX is bus I/F test.
Please set the mode besides bus I/F test.
(3) Board detail information
Error message
It failed in the save of SB/SW. There is a possibility of failing
in the installation.
It failed in the acquisition of SB/SW.
It is not possible to preserve it in the file.
The file path cannot be set exceeding 255 characters.
Please select it again.
Read-only save target.
Please confirm save target and execute it again.
It failed in the save of the SB/SW file.
Confirm the position of the save file.
Failed to read the data.
The board is reset. All right?
Disk space of destination is not enough.
Please specify other destination.
The CC IE Control utility has already been activated.
Execute after completing the activated CC IE Control utility.
The installation of SW1DNC-MNETG-B may be failed.
Reinstall SW1DNC-MNETG-B.
The installation of SW1DNC-MNETG-B may be failed.
Reinstall SW1DNC-MNETG-B.
Check if the driver is started.
• Check if the CC-Link IE Controller Network board is
mounted.
• Start the CC IE Control utility after mounting the CC-Link IE
Controller Network board.
The installation of SW1DNC-MNETG-B may be failed.
Reinstall SW1DNC-MNETG-B.
Set the mode other than bus I/F test.
The installation of SW1DNC-MNETG-B may be failed.
Reinstall SW1DNC-MNETG-B.
The installation of SW1DNC-MNETG-B may be failed.
Reinstall SW1DNC-MNETG-B.
Set the file path within 255 characters.
Cancel the write protection at save location.
Change the file to be specified.
• Restart the CC IE Control utility.
• The installation of SW1DNC-MNETG-B may be failed.
Reinstall SW1DNC-MNETG-B.
• Restart the CC IE Control utility.
• The installation of SW1DNC-MNETG-B may be failed.
Reinstall SW1DNC-MNETG-B.
Reserve the disc space of the write destination.
13.1 List of Error Messages in CC IE Control Utility
13.1.1 Error messages displayed on the board information screen
Corrective action
Corrective action
Corrective action
9
10
11
12
13
14
A
I
13
- 2