Mitsubishi Electric Q80BD-J71GP21-SX User Manual page 130

8
CC IE Control UTILITY
Item
Check
End
Cancel
8
- 24 8.4 Setting Screen
8.4.7 Event setting screen
Description
Checks the event settings.
Reflects the settings, and closes the "Event
setting" screen.
Without reflecting the settings, closes the
"Event setting" screen.
*1: Set the device number and device points -1 not to exceed the range of device number.
*2: Cannot be set when the "Event condition" is set to "Change".
*3: The following table indicates the combination of the event settings and timing of the event
occurrence.
Device code
Level detect
Level detect
LB, LX, SB
Edge detect
Edge detect
Level detect
Level detect
Edge detect
LW, SW
Edge detect
POINT
When the multiple events occur at the same time, smaller setting number is the
priority to be notified.
Default
—
—
—
Detection
Event condition
method
ON
OFF
ON
OFF
Equal
Unequal
Equal
Unequal
— Change
Setting range
—
—
—
Timing of event occurrence
While ON
While OFF
At rising pulse
At falling pulse
When setting values match
When setting values mismatch
When setting values match
(for first detection only)
When setting values mismatch
(for first detection only)
When previous setting values
mismatch