User's Manual
The User Info file is a text-based file that you can create using any text-based program
such as Notepad. To add mapping rules to this file, use the following syntax:
[ GW ]
FORMAT
PBXExtensionNum,GlobalPhoneNum,DisplayName,UserName,Password
Where:
PBXExtensionNum is the PBX extension number (up to 10 characters)
GlobalPhoneNum is the "global" phone number (up to 20 characters) for the IP side
DisplayName is the Caller ID (string of up to 30 characters) of the PBX extension
UserName is the username (string of up to 40 characters) for registering the user
when authentication is necessary
Password is the password (string of up to 20 characters) for registering the user when
authentication is necessary
Each line in the file represents a mapping rule of a single PBX extension user.
You can add up to 1,000 mapping rules. The maximum size of the User Info file is 10,800
bytes for analog interfaces and 108,000 bytes for digital interfaces.
Note:
An example of a configured User Info file is shown below:
[ GW ]
FORMAT
PBXExtensionNum,GlobalPhoneNum,DisplayName,UserName,Password
401 , 638001 , Mike , miked , 1234
402 , 638002 , Lee , leep, 4321
403 , 638003 , Sue , suer, 8790
404 , 638004 , John , johnd, 7694
405 , 638005 , Pam , pame, 3928
406 , 638006 , Steve , steveg, 1119
407 , 638007 , Fred , frede, 8142
408 , 638008 , Maggie , maggiea , 9807
37.1.4.2 User Information File for SBC User Database
You can create a User Info table of SBC users from a loaded User Info file. This User Info
file is the same file used for the GW / IP-to-IP application.
The device can use the SBC User Info for the following:
Registering each user to an external registrar server.
Authenticating (for any SIP request and as a client) each user if challenged by an
external server.
Authenticating as a server incoming user requests (for SBC security).
If the device registers on behalf of users and the users do not perform registration, any SIP
request destined to the user is routed to the Proxy Set associated with the user's IP Group.
The User Info file is a text-based file that you can create using any text-based program
such as Notepad. To add SBC users to this file, use the following syntax:
[ SBC ]
FORMAT LocalUser,UserName,Password,IPGroupID
Version 6.6
Make sure that the last line in the User Info file ends with a carriage return
(i.e., by pressing the <Enter> key).
547
3 7. Software Upgrade
Mediant 800B GW & E-SBC