Switching The Ap To Operate In Fit Ap Mode; Configuring Continuous Transmitting Mode - H3C WA2612-AGN Web-Based Configuration Manual

Figure 444 Setting a district code
2. Configure a district code as described in
3. Click Apply.
Table 137 Configuration items
Item
Country/Region Code
NOTE:
• If the Country/Region Code list is grayed out, the setting is preconfigured to meet the country regulation
of the target market and is locked. It cannot be changed.
Support for the district code configuration depends on the device model.
•

Switching the AP to operate in fit AP mode

1. Select Advanced > Switch to Fit AP from the navigation tree.
2. Click Switch.
Figure 445 Switching to fit AP mode
NOTE:
Before switching the operating mode, make sure the application file of the fit AP has been loaded to the
AC or the unified switch. Otherwise, the AP cannot operate properly after its operating mode is switched.

Configuring continuous transmitting mode

1. Select Advanced > Continuous Transmit from the navigation tree.
Table 137.
Description
Select a district code.
Configure the valid district code for a WLAN device to meet the
country regulations.
414