Advanced Settings Configuration Examples; Band Navigation Configuration Example - H3C WA2612-AGN Web-Based Configuration Manual

Table 142 Field description
Field
Total Clients
Action
Multicast Address
MAC Address

Advanced settings configuration examples

Band navigation configuration example

Network requirements
As shown in
operate at 5 GHz and 2.4 GHz respectively. Client 1, Client 2, and Client 3 are dual-band clients, and
Client 4 is a single-band (2.4 GHz) client. Configure band navigation to direct clients to different radios
of the AP.
Figure 455 Network diagram
Configuring the AP
NOTE:
To enable band navigation to operate properly, make sure the fast association function is disabled. By
•
default, the fast association function is disabled.
Support for the band navigation depends on the device model. For more information, see "Feature
•
matrix."
Description
Total number of clients served by multicast optimization.
If a client joins multiple multicast groups, the client is counted as multiple clients.
For example, if a client has joined two multicast groups through a radio, the
client is counted as two clients by multicast optimization.
Operating status of the multicast optimization function:
•
Optimize—The multicast optimization function is operating.
•
Halt—The multicast optimization function is halted.
Address of the multicast group that the clients has joined.
•
MAC addresses of the clients that have joined the multicast group.
Figure 455, Client 1 through Client 4 try to associate to AP 1, and the two radios of AP 1
421