User Isolation; Configuring User Isolation - H3C WA2612-AGN Web-Based Configuration Manual

User isolation

If an AP has the user isolation feature enabled, clients associated with it are isolated at Layer 2.
As shown in
or learn each other's MAC or IP addresses, because they cannot exchange Layer 2 packets.
Figure 466 Network diagram

Configuring user isolation

1. Select Security > User Isolation from the navigation tree.
Figure 467 Configuring user isolation
2. Configure user isolation as described in
3. Click Apply.
Table 147 Configuration items
Item
User Isolate
Figure 466, after user isolation is enabled on the AP, all the clients cannot ping each other
Description
•
Enable—Enable user isolation on the AP to isolate the clients associated with it
at Layer 2.
•
Disable—Disable the user isolation.
By default, wireless user isolation is enabled.
Table 147.
431