H3C WA2612-AGN Web-Based Configuration Manual page 44

Wa2600 series; wa2600 series; wa2600 series; wa2600 series; wa3600 series; wa3600 series
Hide thumbs Also See for WA2612-AGN:
Table of Contents

Advertisement

Table 19 Field description
Field
MAC Address
AID
User Name
Radio Interface
SSID
BSSID
Port
VLAN
State
Power Save Mode
Wireless Mode
Channel Band-width
SM Power Save Enable
Short GI for 20MHz
Short GI for 40MHz
Support MCS Set
BLOCK ACK-TID
QoS Mode
Listen Interval (Beacon Interval)
RSSI
Rx/Tx Rate
Description
MAC address of the client.
Association ID of the client.
Username of the client:
The field is displayed as -NA- if the client adopts plain-text
authentication or cipher-text authentication with no username.
The field is irrelevant to the portal authentication method. If the client
uses the portal authentication method, the field does not display the
portal username of the client.
Radio interface associated with the client.
SSID associated with the client.
Basic SSID.
WLAN-DBSS interface associated with the client.
Number of the VLAN interface to which the client belongs.
State of the client such as running.
Client's power save mode: active or sleep.
Wireless mode such as 802.11a, 802.11b, 802.11g, 802.11an,
802.11gn.
Support for the display of the wireless mode depends on the device
model.
Channel bandwidth, 20 MHz or 40 MHz.
SM Power Save enables a client to have one antenna in the active state,
and others in sleep state to save power.
Enabled—SM Power Save is supported.
Disabled—SM Power Save is not supported.
Whether the client supports short GI when its channel bandwidth is 20
MHz.
Whether the client supports short GI when its channel bandwidth is 40
MHz.
MCS supported by the client.
BLOCK ACK is negotiated based on QoS priority ID value:
OUT—Outbound direction.
IN—Inbound direction.
BOTH—Both directions.
Whether the AP supports the WMM function.
Specify how often the client wakes up to receive frames saved in the AP
and is expressed in units of beacon interval.
Received signal strength indication. This value indicates the client
signal strength detected by the AP.
Represent the reception/transmission rate of packets (including data,
management and control packets)
31

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents