H3C WA2612-AGN Web-Based Configuration Manual page 70

Table 29 Configuration items
Item
Port State
Speed
Duplex
Link Type
PVID
Description
Enables or disables the interface.
In some cases, modification to the interface parameters does not take effect
immediately. You need to shut down and then bring up the interface to make the
modification work.
Set the transmission rate of the interface.
Available options include:
•
10: 10 Mbps.
•
100: 100 Mbps.
•
1000: 1000 Mbps.
•
Auto: Auto-negotiation.
•
Auto 10: The auto-negotiation rate of the interface is 10 Mbps.
•
Auto 100: The auto-negotiation rate of the interface is 100 Mbps.
•
Auto 1000: The auto-negotiation rate of the interface is 1000 Mbps.
•
Auto 10 100: The auto-negotiation rate of the interface is 10 Mbps or 100 Mbps.
•
Auto 10 1000: The auto-negotiation rate of the interface is 10 Mbps or 1000
Mbps.
•
Auto 100 1000: The auto-negotiation rate of the interface is 100 Mbps or 1000
Mbps.
•
Auto 10 100 1000: The auto-negotiation rate of the interface is 10 Mbps, 100
Mbps or 1000 Mbps.
Set the duplex mode of the interface.
•
Auto: Auto-negotiation.
•
Full: Full duplex.
•
Half: Half duplex.
Set the link type of the current interface, which can be access, hybrid, or trunk. For
more information, see Table
IMPORTANT:
To change the link type of a port from trunk to hybrid or vice versa, you must first set its
link type to access.
Set the default VLAN ID of the hybrid or trunk port.
IMPORTANT:
The trunk ports at the two ends of a link must have the same PVID.
57
30.