H3C WA2612-AGN Web-Based Configuration Manual page 348

Configuring the AP
1. Assign an IP address to the fat AP:
a. Select Network > VLAN to create a VLAN on the fat AP.
b. Select Device > Interface Management to assign an IP address to the VLAN interface.
2. Configure a wireless service
a. Select Wireless Service > Access Service from the navigation tree.
b. Click Add.
c. On the page that appears, set the service name to 11nservice, select the wireless service type
clear, and click Apply.
Figure 360 Create a wireless service
3. Bind an AP radio to a wireless service
a. Select Wireless Service > Access Service from the navigation tree.
b. Click the Bind link at the right side of the wireless service 11nservice to enter the page as shown
in Figure
c. Select the box with radio mode 802.11n(2.4GHz).
d. Click Bind.
Figure 361 Bind an AP radio
Enable the wireless service
4.
a. Select Wireless Service > Access Service from the navigation tree.
b. On the page that appears, select the 11nservice box.
c. Click Enable.
361.
335