Configuring Basic Functions; Configuring Basic Functions For An Ap Operating In Fit Mode; Configuring Basic Functions For An Ap Operating In Fat Mode - H3C WA Series Getting Started Manual

Configuring basic functions

5
The WA series WLAN access points, except for the WA2110-AG that can only operate in
fit mode, can operate in both fat and fit modes, and you can switch the operating
mode of an AP as needed.
Configuring basic functions for an AP operating in fit
mode
An AP operating in fit mode has zero configuration. When it is associated with an access
controller (AC) or unified switch (US), it does not need or save any configuration. All
configurations are performed on the AC or US.
Configuring basic functions for an AP operating in fat
mode
An AP operating in fat mode has the default configuration as follows:
NOTE:
The default output depends on your AP model.
#
version 5.20, Release 1104P01
#
sysname WA2612-AGN
#
domain default enable system
#
telnet server enable
#
port-security enable
#
vlan 1
#
domain system
access-limit disable
state active
16