Table of Contents
Advertisement
Connecting an AC power cord
1.
Make sure the AP is reliably grounded.
2.
Connect one end of the AC power cord to the power port on the AP and the other end to a local
power source.
Figure2-16 Connecting an AC power cord
Verifying the power cord connection
Observe the LEDs on the AP to verify the power cord connection. For more information about the
LEDs, see "Appendix B Ports and LEDs."
Connecting the AP to the network
For the AP to access the Internet or MAN, connect an Ethernet port on the AP to an Ethernet switch.
Verifying network connectivity when the AP operates in fit
mode
When the AP operates in fit mode, all its settings are configured on the AC. Execute the
wlan ap all
associated with the AC and connected to the network.
<AC> display wlan ap all
Total number of APs: 1
Total number of connected APs: 1
Total number of connected manual APs: 1
Total number of connected auto APs: 0
Total number of connected common APs: 1
Total number of connected WTUs: 0
Total number of inside APs: 0
Maximum supported APs: 3072
Remaining APs: 3071
Total AP licenses: 128
Remaining AP licenses: 127
command on the AC. If the AP status in the command output is R/M, the AP has
Pin No.
1
2
3
2-11
1
2
3
Power port on the AP
Name
L
N
PE
display
Advertisement
Table of Contents
