H3C WA2612-AGN Web-Based Configuration Manual page 310

Figure 300 Network diagram
Configuring the AP
1. Configure the fat AP interface:
a. Assign an IP address to the fat AP:
Select Network > VLAN to create a VLAN on the fat AP.
Select Device > Interface Management to assign an IP address to the VLAN interface.
b. Configure the link type of the Ethernet interface on the fat AP as trunk, and allow packets from
VLAN 2 and VLAN 3. For more information, see "VLAN configuration."
2. Configure a wireless service named research:
a. Select Wireless Service > Access Service from the navigation tree.
b. Click Add.
c. On the page that appears, enter the service name research, select the wireless service type
crypto, and click Apply.
d. On the page that appears, enter 2 in the VLAN (Untagged) field, enter 2 in the Default VLAN
field, enter 1 in the Delete VLAN field, and click Apply.
Before you perform these VLAN settings, select Network > VLAN to create VLAN 2 first.
Figure 301 Set the VLANs
NOTE:
For PSK-related configuration, see
configuration example to configure PSK.
3. Configure a wireless service named office:
a. Select Wireless Service > Access Service from the navigation tree.
"WPA-PSK authentication configuration
297
example." You can follow the