Removing The Monitor Post Cover; Removing The Sub Control Panel (Lcd) - Siemens SONOLINE G50 Service Manual

Chapter 4 - Removing and Replacing Spare Parts
!
5. Remove the monitor post cover by loosening the two screws located under
6. Loosen the two screws from the sub control panel shown in Figure 4-24.
Siemens
Caution: In the following steps, hardware removed from the monitor assembly
can fall into the system. Loosen the hardware then carefully remove it to prevent
it falling. If screws or washers fall into the system, do not continue until they have
been recovered.
the handle shown in Figure 4-23.
Figure 4-23 Removing the Monitor Post Cover (View from Under Rear Handle)
Figure 4-24 Removing the Sub Control Panel (LCD)
7482255 Rev 01
October 2002
Rear Handle
Page 29 of 52