Advertisement
WARNING
Observe the following steps for transporting the unit to the OT.
Unlock the C-arm and turn it to the position shown in the figure and lock it. This is the
suitable position for moving the unit from the platform.
Now, release the brake of the C-Arm and swing the C-Arm back to the normal position
as shown in the figure for transportation. This is also the parking position.
Roll all the cables and hang it on the cable holder provided on the housing.
Unbrake the wheels and move the unit to the OT. Use the steering for easy
manoeuvrability.
1.6 Unpacking the monitor trolley
Observe the following steps:
1) Remove the restraining strips by cutting it .Use a cutting plier for this purpose.
2) Remove the top plank.
3) Remove the front and rear wall of the box.
4) Remove the supporting beams fixed across the sidewalls.
5) Remove the side planks. The trolley is mounted on the clamping brackets.
6) Remove the ESD bag.
7) Now, using a spanner of 16-17, remove the clamping brackets.
8) Lift the trolley gently by holding at the base and supporting it from top. Place it on the
floor.
9) Release the brakes and the trolley can be shifted to the OT.
Siemens Ltd. Med India
DO NOT HOLD THE UNIT AT POINTS
MARKED
Version 5.0
Copyright © SIEMENS LTD. All rights reserved. For internal use only
Pre-installation Instructions
Multimobil 5C
WHILE LIFTING
Page 10 of 11
Advertisement
