Installing The G50 Dimaq-Ip; Kit Contents - Siemens SONOLINE G50 Service Manual

Installing the G50 DIMAQ-IP

1.0 Installing the G50 DIMAQ-IP
Use the following methods to install the DIMAQ-IP module on the G50.
See "Removing and Installing the DIMAQ-IP Module" (page 4-24) for remove
and replace procedures appropriate for both the G50 and the G60 S DIMAQ-IP
module.
!
1.1 Tools Required
Use the following tools to install the DIMAQ-IP option:
„ Phillips screwdriver (#1)
„ Phillips screwdriver (#2)
„ Straight-blade screwdriver (.25 inch)
„ Side cutters

1.2 Kit Contents

Verify that the DIMAQ-IP kit contains the items listed in Table 5-1.
Page 2 of 16
Note: The G50 was released with version 1.2 of the system software installed.
The DIMAQ-IP option requires this version 1.2 system-software revision level as
a minimum.
Caution: Static sensitive components and connectors are exposed during this
procedure. Electrostatic discharge (ESD) can damage or destroy electronic
components. Use proper ESD protective procedures during the performance of
this procedure.
Item
(a)
DIMAQ-IP module
(b)
A70-2 PPCL PCB
M3 X 6 screw
M2.5 X 6 screw
External lock washer
Wire Ties
Ethernet cable (straight)
Ethernet cable (cross)
USB cable
VGA cable
Serial cable
Option label
Table 5-1
Part
Number
7478683
7479913
7482255 Rev 01
October 2002
Quantity
1
1
4
2
2
3
1
1
1
1
1
1
Siemens