Siemens SONOLINE G50 Service Manual page 62

Installing the Color Printer and the VCR
6. Hold the bumper, and remove the entire front cover from the G50 or the
7. Pry off six screw caps from the top cover, then remove six M4 X 10 flat head
8. Pull out the top cover from the system as shown in Figure 4-17.
9. Disconnect all of the cables from the rear side of P91W as shown in
10. Unscrew the two M3 X 8 binding head screws and external lock washers
11. Unscrew the four M4 X 8 binding head screws and external lock washers
12. Remove the OEM bay from the G50 or the G60 S.
13. Detach the plastic bag from the OEM bay, and remove the four M3 X 8 flat
14. Remove the two S-type brackets and the separator from the OEM bay by
15. Turn the SVO-9500 upside down.
16. With the bottom of the SVO-9500 facing upward, place the SVO-9500 on a
17. Invert the OEM bay and place it over the bottom surface of the SVO-9500.
18. Using the four M3 X 8 flat head screws removed from the plastic bag,
19. Return the inverted SVO-9500 and the attached OEM bay to their original
20. Place the OEM bay, with the SVO-9500 attached, in its original position in
21. Reinstall the mounting hardware that was initially removed from the OEM
22. Re-install the P91W, still attached to its mounting plate, in the OEM bay.
23. Fasten the front edge of the mounting plate to the bracket F, using two
24. At the SVO-9500, position the S VIDEO IN IMPEDANCE switch to 75 _/
25. Position the number 3 and the number 5 DIP switches in the On position.
26. At the P91W, position the number 1 DIP switch in the On position.
Page 20 of 52
G60 S.
screws and washers as shown in Figure 4-17: Do not remove the two sets
of screws located in the middle.
Figure 4-10.
from bracket F, then remove the P91W and its mounting plate from the
OEM bay.
that attach the OEM bay to the G50 or the G60 S.
head screws provided in this bag.
unscrewing the four M3 X 8 flat head screws that attach them.
padded or protected platform of 25 mm (1 inch) or higher.
secure the OEM bay to the SVO-9500 by installing the four screws through
the holes marked with the character S.
upright position.
the G50 or the G60 S, but do not position the OEM bay all the way toward
the rear; confirm that enough space remains between the SVO-9500 and
the interface panel to re-establish cable connections between them.
bay.
M3 X 8 binding head screws with external lock washers that were removed.
ON.
7482255 Rev 01
October 2002
Siemens