Siemens SONOLINE G50 Service Manual page 79

Chapter 4 - Removing and Replacing Spare Parts
7. Release the cables from the cable clamp located at the upper left of the
8. Disconnect the remaining cables from the DIMAQ-IP module.
9. Loosen the three thumbscrews of the DIMAQ-IP module (Figure 4-38),
10. Create sufficient clearance for dismounting the DIMAQ-IP module safely by
11. Move the DIMAQ-IP module to the left and dismount it from the system.
12. Remove the two screws located under the rear handle and remove the
13. Loosen the two screws indicated in Figure 4-33.
Siemens
DIMAQ-IP module.
Tie-wrap these cables to the adjacent panel.
Figure 4-30 DIMAQ-IP Module Installation
using the short number 2 Phillips screwdriver.
routing the cables in front of it, and to the sides of the DIMAQ-IP module.
Figure 4-31 DIMAQ-IP Module Thumbscrews
monitor post cover from upper G50 or the G60 S as shown in Figure 4-32.
DIMAQ-IP
DIMAQ-IP
7482255 Rev 01
October 2002
Thumbscrews (3)
Page 37 of 52