Installing The Product Feature Keys; Preset Screen - Siemens SONOLINE G50 Service Manual

Installing the Product Feature Keys

3.0 Installing the Product Feature Keys
Use the following instructions to install product feature keys; these keys enable
features that are licensed for use.
See "Uninstalling the Product Feature Keys" (page 8-14) for instructions for the
removal of the feature keys from the system.
1. Energize the G50 or the G60 S.
2. Confirm that the time display located in the upper right corner of the screen
3. Press the F4 key to display the Preset screen shown in Figure 8-2.
4. Use the trackball to select the Installation from Key Disk menu item indi-
Page 10 of 42
Note: The procedure presented here describes the installation of the Stress Echo
feature on the G60 S system; this option requires the presence of the DIMAQ-IP
module.
is correct: Adjust the time display if necessary.
cated in Figure 8-2.
Figure 8-2 Preset Screen
7482255 Rev 01
October 2002
Siemens