Dimaq-Ip Installation; Installing Cable Clamps - Siemens SONOLINE G50 Service Manual

Installing the G50 DIMAQ-IP
30. Install the DIMAQ-IP module in the system and fasten the three screws
!
31. Connect the DIMAQ-IP power cable to the DIMAQ-IP module: See connec-
32. Reinstall the power-cable clamp shown in Figure 5-7 that was removed in
33. Identify the cables that were detached from the host module in step 3.
Page 8 of 16
indicated in Figure 5-8.
Note: When installing the DIMAQ-IP module, verify that no cables are pinched
between parts or surfaces. Push the DIMAQ-IP module in slowly, verifying that no
cables are pinched between the DIMAQ-IP module and the surrounding equip-
ment.
When connecting cables between the DIMAQ-IP module and the host module,
read the connector labels carefully and confirm that the cables are attached to the
proper connector.
Caution: Use fasteners of the correct length to prevent damage to underlying
equipment. See "Fastener Reference" (page H-1).
tion in Figure 5-9 and Figure 5-10.
step 28. See Figure 5-9.
Figure 5-9 Installing Cable Clamps
Figure 5-8 DIMAQ-IP Installation
7482255 Rev 01
October 2002
Siemens