Presetting The Power Meter; Preset Conditions - Agilent Technologies E4418B User Manual

Presetting the Power Meter

This section details the power meter's preset conditions.
The GPIB address and command set, the data stored in the sensor
calibration tables and the zeroing and calibration data are not affected by
a preset. The calibration table selected is not affected.

Preset Conditions

The number of windows displayed is two.
Measurement units used is set to dBm.
•
•
•
•
•
•
•
•
•
•
E4418B Power Meter User's Guide
is set to 50 MHz.
Freq
is set to 100%.
Cal Fac
is set to digital in the upper window and analog in the
Display Format
lower window.
is set to 20.000 dBm (
Anlg Mtr Scaling
Resolution 1 2 3 4
is set to "Off"
Limits Off/On
is set to 90.000 dBm (
Limits
TTL Output Off/On
Limits OVER, UNDER, EITHER
Fail O/P High/Low
is set to "3".
) and –90.000 dBm (
Max
is set to "Off".
is set to "OVER".
is set to "Low"
Power Meter Operation
) and –70.000 dBm (
Max
).
Min
2
).
Min
91